HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 8)

Introduction 8
Command Changes Virtual Connect
3.15 Virtual Connect 3.30
interconnect The "add" and "set"
subcommands were
added to this
command, enabling
you to add an
interconnect to an
enclosure and set the
interconnect host
name, respectively.
Not supported The add
interconnect and
set interconnect
commands are
supported.
help interconnect-mac-table
show interconnect-mac-table
The new object
"interconnect-mac-
table" is supported in
VC 3.30, enabling
you to view
interconnect module
MAC table information
for a specified module.
Not supported All of these commands
are supported.
help lldp
show lldp
The new object "lldp"
is supported in VC
3.30, enabling you to
view LLDP information
received on a
specified port.
Not supported All of these commands
are supported.
help loop-protect
reset loop-protect
show loop-protect
set loop-protect
The new object
"loop-protect" is
supported in VC 3.30,
enabling you to
manage network loop
protection settings.
Not supported All of these commands
are supported.
add nag-network
help nag-network
remove nag-network
show nag-network
The new object
"nag-network" is
supported in VC 3.30,
enabling you to
manage network to
network access group
associations.
Not supported All of these commands
are supported.
add network
set network
The "Nags" property
was added to these
commands, enabling
you to add and modify
networks associated
with network access
groups.
Not supported add network
[Nags=
[,,...
]]
set network
[Nags=
[,,...
]]