HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 46)

Command line 46
Item Description
[TargetName=] [TargetIP=]
[TargetPort=] [TargetIP2=
Target IP>] [TargetPort2=]
[Authentication=] [Username=]
[Secret=] [MutualUsername=]
[MutualSecret=]
[iSCSIBootParamDHCP=]
[NetworkParamDHCP=]
[DHCPVendorID=]
Parameter
ConnectionID
(required)
The ID of an existing iSCSI connection. The ID format is . To
retrieve the port number of the iSCSI connection, use the show profile
command.
Options
maskSecret (optional) Enables you to interactively specify the CHAP secret password as a masked
string at the command prompt.
maskMutualSecret
(optional)
Enables you to interactively specify the mutual CHAP secret password as a
masked string at the prompt.
Properties
BootOrder (optional) Enables or disables iSCSI boot. Valid values for enabling iSCSI boot include
"Primary", "Secondary", or "USE-BIOS". The default value is "Disabled".
LUN (optional) The LUN of the target, which identifies the volume to be accessed. Valid values
for standard LUNs are 0 to 255 decimal values. Valid values for extended LUNs
are 13- to 16-character hexadecimal values. The default value is 0.
InitiatorName
(required if
ISCSIBootParamDHCP is
"Disabled")
The name used for the iSCSI initiator on the booting system. The initiator name
length can be a maximum of 223 characters. If the initiator name string contains
non-alphanumeric characters, it must be enclosed in quotation marks.
InitiatorIP (required
if Network ParamDHCP is
"Disabled")
The IPv4 address used by the iSCSI initiator. This value is in dotted decimal
format.
Mask (required if
NetworkParamDHCP is
"Disabled")
The IP network mask used by the iSCSI initiator. This value is in dotted decimal
format.
Gateway (optional) The default IP route used by the iSCSI initiator. This value is in dotted decimal
format.
VlanID (optional) The VLAN number that the iSCSI initiator uses for all sent and received packets.
Valid values range from 1 to 4094.
TargetName (required if
ISCSIBootParamDHCP is
"Disabled")
The name of the target from which to boot. The target name length is a maximum
of 223 characters. If the name string contains non-alphanumeric characters, it
must be enclosed in quotation marks.
TargetIP (required if
ISCSIBootParamDHCP is
"Disabled")
The primary IPv4 address of the iSCSI target.
TargetPort (optional) The TCP port associated with the primary target IP address. The default value is
3260.
TargetIP2 (optional) The alternate target IPv4 address to use if the primary target IP is unavailable.