HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 21)

Command line 21
Supported actions: add, help, remove, show
Item Description
add banner Add banner text to the login screen. After banner text is added, the login banner
appears and all users are prompted for a yes or no response. If the response is
“yes”, users can continue with login. If the response is "no", the VCM CLI exits.
Syntax
add banner text=[””|’’]
Properties
text (required) The text to display on the login in screen. Multi-line banner text can be entered
through multiple add banner commands. New lines are appended to existing
text. The banner text limit is 1500 bytes. If the accumulated banner text length
exceeds 1500 bytes, either from one or multiple add banner commands, an
error message appears. Only printable characters are allowed.
Examples
->add banner text="This is a private system, unauthorized
access is not allowed."
Adds banner text with a single command
->add banner text="This is a private system."
->add banner text=""
->add banner text="Unauthorized access is prohibited."
->add banner text=""
->add banner text="Communications are monitored."
Adds banner text with multiple commands (A blank line is displayed in between
each line of text in this example.)
Item Description
remove banner Remove configured banner text.
Syntax
remove banner
Example
->remove banner
Removes the configured banner text
Item Description
show banner Display the configured banner text.
Syntax
show banner
Example
->show banner
Displays the configured banner text
config
Display all CLI commands for all objects defined in the domain. The show config command is useful for
generating a CLI script that can be used for creating a domain configuration. The generated script is only
valid for the firmware version currently running. A script generated on one version of firmware is unlikely to
be properly executed by a different version of firmware.
There are no bulk commands. Using the generated CLI script to create a large configuration with more than
300 networks is not recommended, as it can take a long time unless you rewrite the script to use the bulk
commands.