Start monitor, Command option – HP Integrity NonStop J-Series User Manual
Page 159
NonStop AutoTMF Commands
HP NonStop AutoTMF Software User’s Guide—429952-017
6-83
START MONITOR
START MONITOR
Starts a AutoTMF monitor process for one MapDB or all MapDBs.
process
the name of the AutoTMF monitor process to launch.
mapdb-subvol
the MapDB subvolume. This is an alternative method to specify the process to be
started.
If the parameter is omitted, the default monitor is assumed, most commonly
$ZESC. Use the
command to display the current default monitor and MapDB.
option
BACKUP 0-to-15
the cpu number of the backup monitor process.
HOMETERM file-name
the home terminal for the monitor process.
If omitted, the home terminal is set to the default EMS collector. The default
EMS collector is $0, or the EMS collector configured by setting the global
parameter EMSCOLLECTOR.
PRIMARY 0-to-15
the cpu number of the primary monitor process.
PRIORITY 1-to-199
START MONITOR [ process | mapdb-subvol ] [, option ];
option is:
{ BACKUP 0-to-15
}
{
}
{ HOMETERM file-name
}
{
}
{ PRIMARY 0-to-15
}
{
}
{ PRIORITY 1-to-199
}
Note.
Internally, if the default collector is $0, the default hometerm of the
monitor is $ZHOME, as displayed by the TACL command STATUS $monitor-
process-name, because $0 cannot be specified as the hometerm of a process
when the process is launched. Functionally however, the home terminal for the
monitor process is always the default EMS collector, as shown in the output of