HP Integrity NonStop J-Series User Manual
Page 131
NonStop AutoTMF Commands
HP NonStop AutoTMF Software User’s Guide—429952-017
6-55
CREATE MAPDB
If omitted or NONE, the home terminal is set to the default EMS collector. The
default EMS collector is $0, or the EMS collector configured by setting the
global parameter EMSCOLLECTOR.
MONITOR process-name
the AutoTMF monitor process to be associated with MapDB. The name must
have 5 characters, including the $.
The default is $ZESC.
PRIMARY 0-to-15
the cpu number of the primary monitor process.
PRIORITY 1-to-199
the priority of the monitor process.
SECURE "rwep"
specifies the READ, WRITE, EXECUTE and PURGE security attributes of
MapDB tables.
When a MapDB is created, the monitor process is started to provide access to MapDB
tables. All the options specified in this command are used when the monitor process is
started.
Operational procedures should be updated to start the monitor after a system cold
load.
Note.
Internally, if the default collector is $0, the default hometerm of the
monitor is $ZHOME, as displayed by the TACL command STATUS $monitor-
process-name, because $0 cannot be specified as the hometerm of a process
when the process is launched. Functionally however, the home terminal for the
monitor process is always the default EMS collector, as shown in the output of