HP XP7 Storage - Manual (Page 53)

Default: BC/SS
•
System Type
Verify that Open is selected.
Values: Open or Mainframe
Default: Open
Required: Yes
•
Emulation Type OPEN-V is selected.
Required: Yes
•
Offset boundary
Specify if you want to offset the specified LDEV capacity by boundary.
Values: ON or OFF
Default: OFF
•
LDEV Capacity
Complete the following:
- Type the amount of the LDEV capacity you want to create.
Range: (Shown below the text box.)
Values: Decimals up to two decimal places.
- To change the capacity unit, click the unit capacity menu.
Default: TB, GB, MB, and block
Required: Yes
•
Number of LDEVs
Type the number of LDEVs you want to create.
Range: (Shown below the text box.)
Required: Yes
•
LDEV Name
Type a name for the V-VOL.
- For Prefix, type the alphanumeric characters, which become the fixed characters that
precedes the V-VOL number.
Case-sensitive: Yes
- For Initial Number, type the initial number for V-VOL.
Limit: 9 digits
Character limit: 32
4. In the Create LDEVs window of the Create LDEVs wizard, complete the following additional
items and then click Add:
•
For Initial LDEV ID, confirm that an LDEV identification number has been set. To confirm
the used number and unavailable number, complete the following:
a. Click View LDEV IDs.
b. In the View LDEV IDs window, confirm the LDEV ID and then click Close.
•
For SSID, type a 4-digit representation of a hexadecimal number.
Range: 0004 to FFFE
Default: 0004
Workflow for registering virtual volumes 53