HP XP7 Storage - Manual (Page 150)

4. Locate the description of the SSB1/SSB2 error code combination in the following table.
For more information about error codes that are not described in the following table, contact HP
Technical Support.
The following table lists the SSB2 codes, the related RAID Manager command, and the cause of
the error.
Cause of error RAID Manager command SSB2
You cannot run the command because the user authentication is not performed. All commands 9100
You cannot create the FS pair because of a shortage of pair tables. paircreate 9685
You cannot create the FS pair because the pool is not available. paircreate 9700
You cannot create the FS pair because you specified a pool ID different from
the pool ID used by existing pairs with the specified P-VOL. paircreate 9702
You cannot create the FS pair because the volume you specified as the P-VOL
is already used by another FS S-VOL. paircreate 9703
You cannot create the FS pair because the volume you specified as the S-VOL
is already used by another FS P-VOL. paircreate 9704
You cannot create the FS pair because the volume you specified as the S-VOL
is already used by another FS S-VOL. paircreate 9705
You cannot create the FS pair because another FS pair is using the snapshot ID
you specified. paircreate 9706
You cannot create the FS pair because the capacity of the pair that you are
trying to create exceeds the amount of licensed capacity you have reserved. paircreate 9707
The command ended abnormally. You tried to use a command other than
paircreate
for the volume in the pair other than the FS pair.
All commands 9718
This error can also occur if you run the command with an unsupported parameter
specified.
The command ended abnormally because the pair is in a status that the command
does not accept. All commands 9719
This error can also be reported if you run the command with an unsupported
parameter specified.
You cannot create the FS pair because you do not have sufficient SM capacity. paircreate 971A
You cannot restore the FS pair because the volume you specified as the P-VOL
has an S-VOL Disable attribute. pairresync -restore 971F
The command ended abnormally because you have reached SM capacity (FCSE,
FC Z, TPF, and Extension1). All commands 9723
The command ended abnormally because you have reached SM capacity (more
than SM 1). All commands 9724
The command ended abnormally because the LDEV number of the volume you
specified as the FS P-VOL is beyond the specified range. All commands 9725
The command ended abnormally because you specified the unmounted volume
as the FS P-VOL. All commands 9726
The command ended abnormally because you specified a blocked volume as
the FS P-VOL. paircreate, pairsplit,
pairresync, pairresync
-restore 9727
The command ended abnormally because you specified a volume that is in the
process of being shredded or formatted as the FS P-VOL. paircreate, pairsplit,
pairresync, pairresync
-restore 9728
150 RAID Manager command reference