HP XP7 Storage - Manual (Page 148)

A RAID Manager command reference
This describes RAID Manager commands corresponding to actions in the RWC GUI.
Use the RAID Manager to perform FS tasks. You do this by entering commands from a host.
Pair tasks using the RAID Manager or Remote Web Console
You can use the RAID Manager to perform pair tasks. When you use the RAID Manager, perform
tasks by running an existing command for pair tasks or a RAID Manager command.
Using RAID Manager commands, you can store a minimum of 65 snapshot data or use a minimum
of 64 MU numbers. For the pairs which have 0 to 63 MU numbers, you can only use the existing
commands for pair tasks.
The following table shows the pair tasks you can perform, the RAID Manager commands you can
use to perform the task, and the RWC wizard and windows from which to start the task.
RWC RAID Manager command Pair task
Create Pair wizard paircreate Create pair
raidcom add snapshot
Split Pairs wizard paircreate –split Create and split pair
Split Pairs wizard pairsplit Split pair
raidcom modify snapshot
-snapshot_data create
raidcom modify snapshot
-snapshot_data split
Resync Pairs wizard pairresync Normal Copy
raidcom modify snapshot
-snapshot_data resync
Resync Pairs wizard pairresync -restore Reverse Copy
raidcom modify snapshot
-snapshot_data restore
Delete Pairs window pairsplit -S Delete pair
raidcom delete snapshot
RAID Manager pair command results
To avoid getting mixed results, run RAID Manager commands on pairs that are in the required
status.
The following table shows the results of running commands on pairs that do not have the required
status.
RAID Manager command Status
pairsplit -E pairsplit -S pairresync
-restore pairresync pairsplit paircreate
-split paircreate
Ab Ab Np Np Ab Ab Np COPY
Ab Ok Np Np Ok Ok Np PAIR/PFUL
Ab Ok Ok Ok Np Np Ab PSUS/PFUS
Ab Ab Np Np Ab Ab Np RCPY
148 RAID Manager command reference