HP XP Continuous Access Software - Manual (Page 222)

Find the error code from the logs displayed on the RAID Manager window.
Figure 93 (page 222) shows an example of a log displayed on the RAID Manager window.
Figure 93 Example of a Log Displayed on the RAID Manager Window
a.
Error codes appear on the right of SSB=. The alphanumeric characters of last the four
digits on the left of the comma(,) indicates SSB1 (for example, B9E1), and the
alphanumeric characters of the last four digits on the right of the comma (,) indicates
SSB2 (for example, B901).
b. See Table 45 (page 222) and find the meaning of the error code.
For details about the error codes that are not described in Table 45 (page 222) , contact
HP technical support “Calling HP Technical Support” (page 240) .
For more information about RAID Manager, see the HP RAID Manager User Guide.
Table 45 Error Codes and Error Contents When Operating RAID Manager
Error Contents Error Code
(SSB2)
Error Code
(SSB1)
An error occurred in the XP Continuous Access Journal pair operation. B901 B901
B9E0 B9E0
B9E1 B9E1
B9E2 B9E2
B9E4 B9E4
D004 D004
A request of XP Continuous Access Journal Pairresync (suspend transition
mode) was received. However, the command was rejected because the
PIN data existed in the journal volume. 3703
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the emulation types of the 3704
specified master journal group and of the restore journal group were
different.
A request of XP Continuous Access Journal Paircreate (journal suspend
mode) or XP Continuous Access Journal Pairresync (journal resync mode) 3705
was received. However, the command was rejected because the version
of the secondary storage system did not support the corresponding
command.
A request of XP Continuous Access Journal Paircreate (journal suspend
mode) was received. However, the command was rejected because the 3706
specified P-VOL was used as the S-VOL of XP Continuous Access
Synchronous, and the pair status was not PAIR.
A request of XP Continuous Access Journal Pairresync (journal resync
mode) was received. However, the command was rejected because of
one of the following reasons: 3707
•
The specified P-VOL was the P-VOL of XP Continuous Access
Synchronous, and the XP Continuous Access Journal pair status was
not PAIR.
•
The specified P-VOL was the S-VOL of XP Continuous Access
Synchronous, and the XP Continuous Access Journal pair status was
not SSWS.
222 Troubleshooting