HP XP Business Copy Software User Manual
Page 81
ShadowImage for z/OS user guide
81
MODE
COPY = Initial full-volume copy.
NOCOPY = Same as COPY.
RESYNC = Re-established a split or suspended volume pair.
PACE
For DKC emulation type 2105 or 2107: Always medium.
For others: 1 (slow), other than 1 (medium).
CRIT
Not applicable.
ESTPAIR
MSGREQ
YES = Applicable.
NO = Not applicable.
LSS
Primary volume CU number, secondary volume CU number (only for the DKC
emulation type 2105).
SUSPEND
DDNAME |
SYSNAME |
UNITADDRESS
DDNAME = dname = JCL statement identifying the volume.
SYSNAME = sysxxx = SYSNAME in the ASSGN system control statement.
UNITADDRESS = ccuu = device number.
PRI
Primary volume (S-VOL): SSID, serial number, channel connection address.
You can set an additional parameter corresponding to each request instead
of a serial number. For a steady split request, the parameter is
MPS00
. This
request is valid for steady split. The parameter locations and descriptions are
as follows:
Byte 0-6: Fixed value (xF0*7)
Byte 7: Indication of MRCF. ‘M’ = MRCF Å Distinguishes SI390 from TC390.
Byte 8: Subcode-1. ‘P’ = SPLIT
Byte 9: Subcode-2. ‘S’ = Steady Split Å Requests steady split.
Byte 10-11: Not used (xF0*2)
If you set a parameter other than the above parameters, the command will be
rejected.
SEC
Secondary volume (T-VOL): SSID, serial number, channel connection address.
PRIMA
Not applicable.
QUIESCE
For information on the QUIESCE parameter, see ”
” on page 87. (Only for the DKC emulation type 2105)
LSS
Primary volume CU number, secondary volume CU number (only for the DKC
emulation type 2105).
DELPAIR
DDNAME |
SYSNAME |
UNITADDRESS
DDNAME = dname = JCL statement identifying the volume.
SYSNAME = sysxxx = SYSNAME in the ASSGN system control statement.
UNITADDRESS = ccuu = device number.
PRI
Primary volume (S-VOL): SSID, serial number, channel connection address.
SEC
Secondary volume (T-VOL): SSID, serial number, channel connection address.
LSS
Primary volume CU number, secondary volume CU number (only for the DKC
emulation type 2105).
QUERY
DDNAME |
SYSNAME |
UNITADDRESS
DDNAME = dname = JCL statement identifying the volume.
SYSNAME = sysxxx = SYSNAME in the ASSGN system control statement.
UNITADDRESS = ccuu = device number.
Table 22
ICKDSF command parameters (continued)
Command
Parameter
Description