HP Insight Control - Manual (Page 69)

Suggested action
Restart the application station and retry the migration.
Destination VM not powered off on HP integrated Citrix XenServers
During X2V migrations to a destination VM on an HP integrated Citrix XenServer, the VM is
not powered off even when you select the The destination server should be powered off after
migration completes
option.
Suggested action
You must manually power off the VM after the migration is complete.
Starting a new migration after a current migration is stopped
If a migration is stopped by means other than a cancellation or failure, the application station,
source server, and destination server might not recognize that the migration has stopped.
Suggested action
To start a new migration:
1. Restart the migration agent on the source and destination servers.
2. On the application station, close the migration wizard.
3. Restart the Insight Control application service and the Insight Control server migration Web
Service.
4. Reopen the migration wizard.
Unrecoverable sector-read errors on the source server hard drive are not supported
and fail a Windows P2P or P2V migration
The following error message might appear if a volume with unrecoverable sector-read errors is
migrated: Server Migrationfailed. ReadFile failed.
Cause
Hard drives automatically take corrective action when they have difficulty reading a sector.
These sectors are marked as “bad sectors” and relocated to one of the sparse sectors in a reserved
area of the hard disk. In these cases, no read error is produced, and the drive continues to function
properly. The data is lost and a read error is propagated to the operating system only if the
surface error rate is too high and additional sparse sectors are not available, or when the sector
is completely unreadable from the beginning.
If file system tools are used to detect these failing sectors (for example, CHKDSK /p /r), the
clusters are marked as “bad.” However the data cannot usually be recovered. In such cases, the
system is not consistent, and proper migration is not possible.
Suggested action
Insight Control does not support the migration of volumes with unrecoverable bad sectors.
Source agent fails to launch when source server reboots in migration agent mode
Suggested action
1. To return to the original configuration, reboot the source server to Profile 1 Hardware Profile.
2. Remove server migration Source Agent Mode manually.
a.
Right-click My Computer, and then select Properties.
b. Click the Hardware tab, and then select Hardware profiles.
c. Select server migration Source Agent Mode, and then click Delete.
Migration process 69