HP Insight Control - Manual (Page 34)

Figure 6-3 Windows Source Agent screen
4. Record the IP addresses listed for the source server entry when using Insight Control server
migration.
After the application station is connected to the migration agent on these servers, the agent
is locked to the application station.
CAUTION: The agent deployment automatically stops the firewall.
5. To unlock the connection between the application station and the source server, or to stop
the server migration Source Agent, access the agent console on the source server, and then
click Abort and Exit.
Deploying a server migration Source Agent on domain controllers
Insight Control server migration supports migration of domain controllers.
To deploy source migration agent on a source server domain controller:
1. Reboot the server.
2. During reboot, press F8 to boot to DSRM.
3. Launch the migration agent in DSRM mode.
The migration runs in Directory Services Restore Mode instead of booting into migration agent
mode. As a result, CHKDSK does not run before the migration of domain controllers.
34 Preparing the source server and deploying the Source Agent