HP NonStop G-Series - Manual (Page 118)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk (Release 2) User’s Guide — 523968-001
6- 48
Fatal Application Error Messages
Cause. The SCC unexpectedly executed self diagnostics during command execution,
and the self-diagnostics failed. A reset or PON condition might have occurred on the
switch module.
Effect. SWCI does not work properly.
Recovery. Do the following:
1. Check the configuration of the switch module device and reconfigure if necessary.
2. Check the version of SWCI installed.
3. Power the switch module device off then back on again.
Fatal Application Error Messages
One of these messages is displayed if an unrecoverable run-time error occurs during
SWCI application execution. Since this class of error typically indicates a programming
defect, the internal code function in which the error occurred is displayed for diagnostic
purposes. Any occurrence of an error in this class causes SWCI to immediately
terminate.
Cause. SWCI code has reached an invalid state in the specified function.
Effect. SWCI stops immediately.
Recovery. Contact professional services.
Cause. An attempt to dynamically allocate memory within the specified function did
not complete successfully.
Effect. SWCI stops immediately.
Recovery. Contact professional services.
***PROTOCOL ERROR*** SCC-detected self-diagnostic error.
***FATAL ERROR*** Code consistency error in function name.
***FATAL ERROR*** Memory allocation error in function name.