HP NonStop G-Series - Manual (Page 113)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk (Release 2) User’s Guide — 523968-001
6- 43
Switch Protocol Error Messages
Recovery. Do the following:
1. Check the configuration of the switch module device and reconfigure if necessary.
2. Check the version of SWCI installed.
3. Power the switch module device off then back on again.
Cause. The manufacture date/time field of an SCC or switch card FIR string read from
the switch module is not present or is incorrectly specified.
Effect. SWCI does not work properly.
Recovery. Do the following:
1. Check the configuration of the switch module device and reconfigure if necessary.
2. Check the version of SWCI installed.
3. Power the switch module device off then back on again.
Cause. The manufacture date field header of an SCC or switch card FIR string read
from the switch module is incorrectly specified.
Effect. SWCI does not work properly.
Recovery. Do the following:
1. Check the configuration of the switch module device and reconfigure if necessary.
2. Check the version of SWCI installed.
3. Power the switch module device off then back on again.
Cause. The manufacture time field header of an SCC FIR or switch card FIR string
read from the switch module is incorrectly specified.
Effect. SWCI does not work properly.
***PROTOCOL ERROR*** Bad manufacture date field in SCC/SC FIR
string.
***PROTOCOL ERROR*** Bad manufacture date header in SCC/SC
FIR string.
***PROTOCOL ERROR*** Bad manufacture time header in SCC/SC
FIR string.