HP NonStop G-Series - Manual (Page 101)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk (Release 2) User’s Guide — 523968-001
6- 31
Command Input/Parsing Error Messages
Cause. The specified input command is not in the SWCI command set.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Enter another command or retry the command with correct syntax.
Cause. After execution of all commands in a command file specified by the SWCI
OBEY command, SWCI could not successfully close the command file. This error is
followed by a one-line textual description of the type of error encountered.
Effect. SWCI waits for the next command.
Recovery. Close the command file.
Cause. An error occurred during an attempt to obtain the next SWCI command from
the current input device. This error is followed by a one-line textual description of the
type of error encountered.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the command with correct syntax.
***COMMAND ERROR*** Unrecognized command
***ERROR*** Close of obey file unsuccessful.
***ERROR*** Command input read error.