HP StorageWorks XP Remote Web Console Software - Manual (Page 214)

Getting Pair Information (Pair Tag)
By specifying the LDKC and CU in the Pair tag, you can get Universal Replicator for Mainframe
pair information in a specified range. Note that you might not get Simplex volume information. If
no Universal Replicator for Mainframe pair exists in the specified range, the output will be only
the Pair tag.
The following table shows the parameters and contents that results from using the Pair tag.
Table 43 Pair Tag Parameters and Contents
Content Parameter Column
Pair status (See “Universal Replicator for Mainframe Data Volume Pair Status” (page 39)
for detailed information)
Status A
LDKC number of the primary data volume LDKC B
CU number of the primary data volume CU C
LDEV number of the primary data volume LDEV D
LDKC number of the secondary data volume LDKC(S) E
CU number of the secondary data volume CU(S) F
LDEV number of the secondary data volume LDEV(S) G
Mirror ID MirrorID H
ID number of the master journal group M-JNL I
The number of the remote journal group R-JNL J
Serial number of the secondary storage system DKCSN K
Controller ID of the secondary storage system ControllerID L
Path group ID PathGroup M
Copy mode specified when you create the pair
1
CopyMode N
Priority specified when you create or resynchronize the pair Priority O
Error level specified when you created or resynchronized the pair, or changed the option
of that pair ErrorLevel P
CFW specified when you created or resynchronized the pair, or changed the option of the
pair. CFW is the setting that specifies whether the Cache-fast-write data will be copied to
the secondary data volume or not. CFW Q
1 Even if you specify None for the Copy Mode parameter when creating a pair using the AddPair tag, the Pair tag
outputs Entire for this item. In addition, if the delta resync operation is performed after the pair creation, the output
copy mode may be different from the copy mode specified when the pair was created.
The information received by the Pair tag will be output in a file named
RemoteCopyJournalMF_Pair_XX.spd. In the file, each single line expresses the information
for one pair. If more than 65,536 lines result from a single operation, the file will be divided. An
XX indicates the sequential number starts from 01. However, the XP24000/XP20000 Disk Arrays
only allow 32,768 Universal Replicator for Mainframe pairs, therefore the output information will
not exceed 65,536 lines. In this case, the file would not be divided and a file named
RemoteCopyJournalMF_Pair_00.spd will be created.
Creating Pairs (AddPair Tag)
Use the AddPair tag to create the Universal Replicator for Mainframe pair. Import the spreadsheet
to the primary site and then perform the CLI by using the spreadsheet with the AddPair tag from
214 Using Spreadsheets for Universal Replicator for Mainframe Operations