HP StorageWorks XP Remote Web Console Software User Manual
Page 174
3.
Do either of the following:
•
In the tree, right-click a journal group from below Registered and then select JNL Groups
and Change JNL Option from the pop-up menu.
•
In the upper-right list, right-click the desired journal group and then select JNL Groups
and Change JNL Option from the pop-up menu.
CAUTION:
You can select Change JNL Option only when one of the following conditions is
satisfied:
•
The attribute of the journal group is Initial.
•
The status of the journal group is Active.
•
The status of the journal group is Stop.
•
The status of the journal group is Hold.
•
The status of the journal group is Holding.
•
The status of the journal group is Hold(Failure).
When one journal group uses multiple mirror IDs, whether you can or cannot select Change
JNL Option depends on the status of the journal group whose mirror is not in Hold, Holding,
or Hold(Failure) status.
4.
In the Change JNL Option window (
), change journal group options and
then click Set.
CAUTION:
If the status of the journal group is Active, or if the status of the master journal
group is Hold or Holding you can change only the Line of Speed option.
NOTE:
If you have selected two or more journal groups in step
, and want to make some
options in the Change JNL Options window unchanged, then you must specify blank for the
options. If you specify blank for an option, the option value will remain unchanged. If you
specify a value other than blank, the specified value will be set to the selected journal groups.
5.
See the Preview list in the Journal Operation window to check the settings that you have made.
•
To modify a setting, select and right-click the setting in the Preview list and then select
Modify.
•
To cancel a setting, select and right-click the setting and then select Cancel.
6.
Click Apply to apply the settings.
174
Configuring Journal Groups