Login, Show, Login show – HP XP P9000 for Compatible High Perf FICON Connectivity Software User Manual
Page 98
login
Description
This e subcommand uses a user ID and a password to log the specified user in SVP.
The svpip subcommand must execute before the login subcommand executes.
The login subcommand fails if monitoring data does not exist in SVP.
Syntax
login userid password
Operands
Description
Operand
Specifies the user ID for SVP.
userid
If the user ID includes any non-alphanumeric character, the user ID must be enclosed by double
quotation marks (").
Be sure to specify a user ID that should be used exclusively with the Export Tool. For detailed
information, see
Specifies the password of the user.
password
If the password includes any non-alphanumeric character, the password ID must be enclosed
by double quotation marks (").
Example
This example logs the user expusr into SVP whose IP address is 158.214.127.170. The password
is pswd.
svpip 158.214.127.170 login expuser pswd
show
Description
This subcommand outputs the following information to the standard output (for example, to the
command prompt):
•
the period during which monitoring data was collected onto SVP (storing period)
•
the interval at which the monitoring data was collected (gathering interval)
Performance Monitor collects statistics by the two types of storing periods: in short range and in
long range. In short-range monitoring, the monitoring data between 8 hours and 15 days is stored
in SVP, and in long-range monitoring, the monitoring data up to 3 months is stored in SVP. For
details on the two storing periods, see
and
Storing periods output by the show subcommand are the same as the information displayed in the
Monitoring Term area of the Monitor Performance window.
Figure 19 The monitoring term area
The login command must execute before the show subcommand executes.
98
Export Tool