Log files, Error handling, Log files error handling – HP XP P9000 for Compatible High Perf FICON Connectivity Software User Manual
Page 94
Log files
When the Export Tool runs, the Export Tool creates a new log file on your system. Therefore, if
you run the Export Tool repeatedly, the size of free space on your system will be reduced. To secure
free space on your system, you are strongly recommended to delete the Export Tool log files
regularly. For details about the location of the log files, see
The Export Tool returns a termination code when the Export Tool finishes.
Table 9 Termination codes returned by the export tool
Meaning
Termination
code
The Export Tool finished successfully.
0
An error occurred when the set subcommand (see
) executed, because an attempt to switch
to Modify mode failed. Some other user might have been logged on in Modify mode.
1
One of the following two errors occurred;
2
•
A command file has been corrupted or could not be read.
•
An error occurred when a command was parsed.
An error occurred due to more than one reason. One of the reasons is that an attempt to switch to
Modify mode failed when the set subcommand (see
) executed. Some other user might
have been logged on in Modify mode.
3
The Storage Administrator (Performance Management) role is not assigned to the user ID.
4
Error handling
When an internal error occurs during export processing, an exclamation mark (!) appears to signal
an error. By default, the Export Tool makes up to three more attempts at processing. You can
change the maximum number of retries by using the retry subcommand. For detailed information
about the retry subcommand, see
If export processing does not finish within three retries or if an internal error occurs other than those
listed in the following table, the Export Tool stops. If the Export Tool stops, quit the command
prompt, and then run the tool again.
For more information, see
Errors for which export tool retries processing
Cause of error
Error message ID
An error occurred during SVP processing.
0001 4001
Because SVP is busy, the monitoring data cannot be obtained.
0001 5400
An administrator is changing a system environment file.
0001 5508
Array is refreshing, or the settings by the user are registered.
0002 2016
The storage system is in internal process, or some other user is changing configuration.
0002 5510
Now processing.
0002 6502
Another user has lock.
0002 9000
A service engineer is accessing the storage system in Modify mode.
0003 2016
SVP is not ready yet, or an internal processing is being executed.
0003 2033
An error occurred during SVP processing.
0003 3006
The storage system status is invalid.
0405 8003
An internal process is being executed, or maintenance is in progress.
5205 2003
94
Export Tool