HP NonStop G-Series - Manual (Page 27)

4.2.2. Installing NonStop Agent EMS Template
In order to map the PE Agent Subsystem ID to its Subsystem Name for generated
EMS messages by PE Agent, the PE Agent EMS template file needs to be installed.
This will cause the PE Agent messages to show up as TANDEM.ZPE instead of
TANDEM.282.
To install the NonStop PE Agent EMS templates. Please follow the steps listed below:
1. Logon to the system as SUPER.SUPER. Go to the PE Agent installation
Subvolume and run the following command.
 Run PETMPAK
2. Determine the volume where the installation subvolume ZINSAIDS is located.
This subvolume should have been placed on your system when you installed
your last SUT-based products.
3. Enter the following command at the TACL prompt.
 LOAD / KEEP 1 / $.ZINSAIDS.TACLMACS
where $ is where the ZINSAIDS subvolume is located.
4. Volume to $SYSTEM.ZTEMPL. This is the subvolume where the individual
product templates are located.
5. Move the new PE Agent template file (ZPETMPL) to $SYSTEM.ZTEMPL. For
example, if you installed the PE Agent software on $SYSTEM.ZPETMPL, then
enter the following command.
 FUP DUP $SYSTEM.ZPE.ZPETMPL, *, PURGE, SAVEALL
6. Determine the names and location of your current resident and non-resident
template files using the following command.
 SCF INFO SUBSYS $ZZKRN
7. Volume to the location where the template files are located. For this example,
assume they are located on $SYSTEM.SYS00.
Performance Essentials HP SIM Client and NonStop & Linux Host User Guide – 544813 – 004
27