HP ProLiant BL10e G2 Server Blade - Manual (Page 143)

Setting Up the System
4. Type the string.
IMPORTANT: Entering a blank string into the Read Community field sets the Read
Community to “public.” Entering a blank string into the Write Community field disables
the SNMP set commands.
5. Click Apply.
To enter a read community or write community string using the CLI, enter:
SET SNMP COMMUNITY [READ | WRITE]
The write must be 0-20 characters long and the read
must be 1-20 characters long. Both community names support
all alphanumeric characters, the underscore, and the dash characters.
The default read community name is “public,” and the default write community name
is blank.
Modifying the System Location
IMPORTANT: The SNMP protocol can be disabled in the Network Configuration area of the
Web-based user interface. See the “SNMP Configuration” section in Chapter 3, “Web-Based
User Interface.”
To modify the system location information using the Web-based user interface:
1. Click the Enclosure tab.
2. Click SNMP Configuration in the left panel.
3. Set the cursor in the System Location field and type the appropriate information.
4. Click Apply.
To modify the system location information using the CLI, enter:
SET SNMP LOCATION
The field must be 0-20 characters long and supports all the alphanumeric
characters, the underscore, the dash, and spaces with quotes.
5-28 HP ProLiant BL e-Class Integrated Administrator User Guide
HP CONFIDENTIAL
Writer: Hilary Stead File Name: f-ch5 Setting Up the System.doc
Codename: Halo Part Number: 249070-005 Last Saved On: 3/1/04 10:50 AM