AMX TPI-PRO-2 User Manual
Tpi-pro
This manual is related to the following products:
Table of contents
Document Outline
- TPI-PRO Total Presentation Interface - Pro Edition Operation/Reference Guide
- Overview
- Installation
- Wiring and Device Connections
- TPI-PRO and Panel Interface Setup
- Configuring Communication
- Setting up the TPI-PRO Device Number
- Configuring a Wired Ethernet Connection
- Step 1: Configuring the Panel’s IP Settings
- Step 2: Choosing a Master Connection Mode Setting
- Step 3: Configuring the Ethernet Connection Type
- Master Connection section - NetLinx Master Ethernet IP Address - URL Mode
- Master Connection section - NetLinx Master Ethernet IP Address - Listen Mode
- Master Connection section - NetLinx Master Ethernet IP Address - Auto Mode
- Master Connection section - NetLinx Master Ethernet IP Address - NDP (UDP) Mode
- Master Connection section - NetLinx Master Ethernet IP Address - URL (UDP) Mode
- Using G4 Web Control® to Interact with a G4 Panel
- Using your NetLinx Master to Control the Unit
- Upgrading TPI-PRO Firmware
- Firmware Pages and Descriptions
- Setup Navigation Buttons
- Setup Page
- Protected Setup Navigation Buttons
- Protected Setup Page
- G4 Web Control Page
- Password Setup Page
- Calibration Page
- System Settings Page
- Cache Page
- Setting the image cache
- Clearing the image cache
- Checking image cache status
- Panel Logs Page
- Checking the Panel Connection Logs
- Refreshing the Panel Connections Log
- Clearing the Panel Connections Log
- Panel Statistics Page
- Checking the Panel Statistics
- Refreshing the Panel Statistics
- Clearing the Panel Statistics
- Connection Utility Page
- Using the Connection Utility
- Programming
- Troubleshooting
- Appendix