AMX TPI-PRO-2 - Manual (Page 96)

Programming
90 TPI-PRO Total Presentation Interface - Pro Edition
"^" Button Commands (Cont.)
^BIM
Set the input
mask for the
specified address.
Syntax:
"'^BIM-,'"
Variable:
variable text address range = 1 - 4000.
input mask = Refer to the Text Area Input Masking section on page 136 for character
types.
Example:
SEND_COMMAND Panel,"'^BIM-500,AAAAAAAAAA'"
Sets the input mask to ten ’A’ characters, that are required, to either a letter or digit (entry
is required).
^BLN
Set the number of
lines removed
equally from the
top and bottom of
a composite video
signal.
The maximum number of lines to remove is 240. A value of 0 will display the incoming
video signal unaffected. This command is used to scale non 4x3 video images into non
4x3 video buttons.
Syntax:
"'^BLN-,,'"Variable:variable text address range = 1 - 4000.button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and 2 = On state).number of lines = 0 - 240.Example:SEND_COMMAND Panel,"'^BLN-500,55'"Equally removes 55 lines from the top and 55 lines from the bottom of the video button.
Variable:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).
number of lines = 0 - 240.
Example:
SEND_COMMAND Panel,"'^BLN-500,55'"
Equally removes 55 lines from the top and 55 lines from the bottom of the video button.