Brother MFC 8220 - Manual (Page 122)

10 - 1 MAKING COPIES
10
Using the MFC as a copier
You can use your MFC as a copier, making up to 99 copies at a time.
Enter Copy mode
Before making copies, make sure that ( Copy ) is illuminated
in green. If it is not, press ( Copy ) to enter Copy mode. The
default setting is Fax. You can change the number of seconds or
minutes that the MFC stays in Copy mode after a copy operation.
(See Setting the Mode Timer on page 4-6.)
The printable area of your MFC begins at approximately 2 mm from
the both ends and 3 mm from the top or bottom of the paper.
Making copies
While the MFC is copying, incoming faxes will be received into
the memory instead of being printed.
3 mm
2 mm
Not
copiable
area
Ex: A4 (Document)
→ A4 (Paper)