Brother MFC 8220 - Manual (Page 127)

10 - 1 MAKING COPIES
10
Using the MFC as a copier
You can use your MFC as a copier, making up to 99 copies at a time.
Enter Copy mode
Before making copies, make sure that ( Copy ) is illuminated
in green. If it is not, press ( Copy ) to enter Copy mode. The
default setting is Fax. You can change the number of seconds or
minutes that the MFC stays in Copy mode after a copy operation.
(See Setting the Mode Timer on page 4-5.)
The printable area of your MFC begins at approximately 0.17 in.
(4.32 mm) from both sides and 0.12 in. (3 mm) from the top or bottom
of the paper.
Making copies
While the MFC is copying, incoming faxes will be received into
the memory instead of being printed.
Unprintable
area
0.12" (3 mm)
0.17" (4.32 mm)
Ex: Letter (Original) Letter (Paper)