Apple Xserve G5 - Manual (Page 51)

Chapter 3 Installing Your Server in a Rack 51
Installing the Server in a Two-Post (Telco) Rack
The server attaches to a two-post rack at the center of the enclosure, so that the front
and back of the server extend beyond the rack.
Important: Before installing the server in a two-post rack, make certain that the rack is
securely fastened to the floor. Also check the rack’s documentation for any specific
installation instructions.
Follow these steps to install the server in a two-post rack. (These instructions assume
that you have previously taken the cover off the server; see “Preparing the Server for
Installation” on page 28 for details.)
1 Attach the small L-shaped brackets to the sides of the server enclosure’s cover with four
of the short screws provided.
Orient the bracket so that the screws are at the top. Attach the brackets to holes that
are about one-third of the way back from the front panel.
Attach the two telco mounting brackets to the server’s cover
using four of the short screws provided.