Apple Xserve G5 - Manual (Page 36)

36 Chapter 3 Installing Your Server in a Rack
7 Slide the brace forward or backward so that the flat end of the brace is flush with the
back post of the rack, and screw the brace’s flange to the post.
8 Attach the second bracket and brace, as described in steps 3 through 7.
Note: If your rack is deeper than the server, the braces and brackets extend beyond the
server’s back panel to the rack’s posts.
Place the Server in the Rack
Once you’ve attached the cover, you can put the server into the rack.
1 At the front of the rack, lift the server to the level where the enclosure’s cover is
installed and slide the server into the cover.
Attach the cover
to the two rear rack
posts using four of the
screws provided.
Insert the server into the cover
and slide it all the way back.