Proseries, Sonic-pro, 4 setup (configuration) mode – Blue-White Sonic-Pro Hybrid Ultrasonic Flowmeters User Manual
Page 22
Page 22
Sonic-Pro
Industries, Ltd.
Industries, Ltd.
ProSeries
by Blue-White Ind.
TM
From the Setup mode, a zero calibration can be performed or, if equipped with either the
full function display (Model S3) or the optional Communications software, the Setup
Root Menu system can be entered and the meter can be configured.
The flowmeter indicates that it is in the Setup Mode as follows:
The flowmeter will remain in the Setup Mode until one of the following actions occur:
1) A Configuration Set is activated from the Setup Root Menu.
Either t
2) The user “escapes” from this state.
The user can escape to the Startup state by:
a) Hold the SETUP button on the motherboard for three seconds.
b) Tap the SETUP button on the motherboard once (resulting in entering the
Transducer Positioning state) and tap again (resulting in entering the Startup
state).
c)
Press the ESC button on the
Note that if the user escapes, the currently active configuration set will re-activate.
3) Five minutes passes without user action.
The operations that
can be performed in the Setup Root Menu are fully described in section 5.0.
The Setup Mode can be entered in two ways:
1) Tap the SETUP button on the motherboard, the display touch-pad, or on the user PC
Communications Software.
2) Flip the Doppler/Transit Time switch.
Note: the meter must be in the Startup State or in the Run Mode to enter the Setup Mode.
he full function display (Model S3) or the optional Communications software
is required for this action.
full function display (Model S3) or on the optional
Communications software.
4.4
Setup
(Configuration)
Mode
Model S1: two outer yellow LEDs flash at 1
Hz.
Model S2: as for Model S1, plus the display
screen indicates:
Setup Mode...
Model S3: as for Model S2, plus the Setup
Root Menu appears.
SETUP MODE
Setup …
Information Screen
Blue-White Industries, Sonic-Pro
Firmware Version, A01.00.00
MODEL S2
ENTER
Ç
ESC
È
Setup Root Menu
Manage Configuration Sets
Global Configuration
MODEL S3