Blue-White F-461 Polysulfone Molded - Manual

Specifications
Meter Body: Polysulfone, natural
Float Stops: Polysulfone, natural
Floats: PTFE
Adapters: PVDF or PVC*
O-Rings: Viton
Half-Union: Anodized aluminum, optional PVC
Scale: Permanent dual scale silkscreen
Maximum Pressure: 150 PSIG / 10.34 BAR at ambient temperature
Maximum Temperature:
See reverse side for Temperature Vs. Pressure graph
Dimensions (refer to drawing on right):
F-460 (1/2” and 3/4” female NPT)
Dim A = 1.75” (4.45 cm)
Dim B = 10” (25.4 cm)
F-461 (1” female NPT)
Dim A = 2.75” (6.99 cm)
Dim B = 15” (38.1 cm)
® Your Blue-White Ultra Pure In-Line Flowmeter
® Your Blue-White flowmeter was designed to be easy to install.
Please read the following instructions before installing your flowmeter.
This flowmeter is an instrument, and special care should be taken when installing.
Installation
Please use the following steps to guide you through the installation.
STEP 1. Unpack the flowmeter.
Check for damage while unpacking the flowmeter.
Make sure pressure, temperature, fluid and other requirements are compatible with the
meter.
STEP 2. Choose a suitable location for the flowmeter.
Never allow the flowmeter to support the weight of related pipe or tubing.
Flowmeter must be installed in plumbing which is free of vibration.
Flowmeter must be installed in an exact vertical plane to ensure accuracy.
The meter body is constructed of polysulfone. Polysulfone has a high chemical resis-
tance**, but a low UV tolerance. Keep meter away from direct sunlight.
Be certain the meter is properly aligned with existing plumbing. Misalignment may result
in damage to the flowmeter.
STEP 3. Connecting the flowmeter to the plumbing.
® Use an appropriate amount of PTFE (or similar) tape on external pipe threads before
making connections.
See installation guideline on the back of this instruction sheet.
80000-324 09/18/2012
5300 Business Drive
Huntington Beach, CA 92649 USA
Dim B
Dim A
Adapter (2)
Half-Union (2)
Meter Body (1)
Scale (1)
Float (1)
Float Stop (2)
(inside)
* PVC has a temperature limit of 130°F / 54.4°C
** Flowmeters are tested and calibrated for water or air only.
Although meters may be suitable for other chemicals, Blue-White cannot guarantee their suitability.
Visit our website to see other available flow ranges and pipe sizes. www.Blue-White.com
Installation Instructions
F-460 and F-461 (ultra pure)
Blue-White
Industries, Ltd.
R