Blue-White Sonic-Pro Hybrid Ultrasonic Flowmeters - Manual (Page 17)

Page 17 Sonic-Pro
Industries, Ltd. Industries, Ltd.
ProSeries
by Blue-White Ind.
TM
3.4
Panel
Mounting
3.5
Pipe
Mounting
7.90” (200mm) 1) The SPU can be panel mounted.
Measure and cut an opening in the
panel as shown.
2) Remove the two mounting plates from
the rear of the enclosure.
3) Install the gasket onto the rear of the
front panel of the SPU enclosure.
4) Place the enclosure into the panel.
5) Re-install the two mounting plates as
shown.
6) Thread the four 8-32 x 3.00” machine
screws through each of the two outer
tapped holes in the mounting plates.
Tighten the screws to secure the
enclosure to the panel.
10.40”
(264mm)
1) The SPU can be mounted on horizontal
or vertical pipe. The pipe must be secure
and of sufficient strength to support the
weight of the SPU.
2) Install the two mounting plates onto the
rear of the enclosure. For horizontal
pipe mounting, install the mounting
plates on the top and bottom plate cut-
outs. For vertical pipe mounting, install
the mounting plates on the side plate
cut-outs.
3) Thread the long mounting clamp
through the square cut-outs in the
mounting plates as shown.
4) Wrap the clamp around the pipe and
tighten loosely. Be sure the pipe is
seated in the pipe groove, then tighten
securely.
Panel
Mounting
Plates
Gasket
8-32 x 3.00”
Panel Screws