Blue-White Sonic-Pro Hybrid Ultrasonic Flowmeters - Manual (Page 12)

Page 12 Sonic-Pro
Industries, Ltd. Industries, Ltd.
ProSeries
by Blue-White Ind.
TM
SERIAL LABEL
FAULT INDICATOR SCREEN
81
Attempting Correction...
1 T 0.88 in. [ £] F81
FAULT
£ £ £
U.S. Gallons
U.S. Gallons / min
625.38
4345625.38
SETUP SWAP CLEAR
1 T 0.88 in. [¢¢¢£]
Separation Distance
RUN MODE SCREEN
1490
NEW CONFIGURATION
ACTIVATION SCREEN
5
Determine the 2nd
transducer location
When operated in the
Doppler mode, the
transducers are always
mounted directly opposite each
other, 180 degrees around the
pipe.
When operated in the
Transit-Time mode, the
factory configured separation
distance and mounting mode
is printed on the serial label.
The currently active
separation distance is also
displayed on the run mode
screen, the fault indicator
screen, and when activating a
new configuration.
If the meter has not been
factory configured, or if a new
configuration is required, the
pipe outside diameter, pipe
wall thickness, pipe material,
fluid type and transducer
mounting mode data must be
input before proceeding.
Once activated, the new
separation distance will be
displayed.
DOPPLER
All pipe types and sizes
“V” Mount Mode
Typically smaller pipe
sizes from 2” to 6”
Separation
Distance
TRANSIT TIME
“Z” Mount Mode
Typically larger pipe
sizes from 4” to 100”
Separation
Distance
Position the transducers
at a separation distance of:
Transducer Positioning …
0.884416 inches (”V” Mount)
Firmware Version, A01.00.00
Press DONE when this is complete
DONE
Information Screen
6
Configure the meter if it has not been factory configured
ENTER Ç ESC È
Setup Root Menu
Manage Configuration Sets
ÊActivate a Configuration Set
Open a Saved Configuration Set
Create a New Configuration Set
Delete a Saved Configuration Set
1. Press Setup.
U.S. Gallons
U.S. Gallons / min
625.38
4345625.38
SETUP SWAP CLEAR ENTER Ç ESC È
Setup Root Menu
Manage Configuration Sets
Global Configuration
1 T 0.88 in. [¢¢¢£] 1490
2. Highlight Manage
Configuration Sets and
press enter. 3. Highlight Open a
saved Configuration
set and press enter. 4. Highlight the
Configuration set to be
edited and press enter.
ENTER Ç ESC È
Setup Root Menu
Manage Configuration Sets
Open a Saved Configuration Set
Ê Configuration Set #1
Ê
See section 6.6 for more information
See section 5.0 for more information
Apply power to the meter. note that only the most basic configuration requirements are shown here.