West Control Solutions KS 92-1 Programmer manual User Manual
Ks90-1
This manual is related to the following products:
Table of contents
Document Outline
- Content
- 1. Mounting 5
- 2. Electrical connections 6
- 3. Operation 11
- 3.1 Front view 11
- 3.2 Behaviour after power-on 12
- 3.3 Operating level 12
- 3.4 Error list / Maintenance manager 13
- 3.5 Self-tuning 15
- 3.5.1 Preparation for self-tuning 16
- 3.5.2 Optimization after start-up or at the set-point 16
- 3.5.3 Selecting the method ( ConF/ Cntr/ tunE) 17
- 3.5.4 Step attempt after start-up 17
- 3.5.5 Pulse attempt after start-up 17
- 3.5.6 Optimization at the set-point 18
- 3.5.7 Optimization at the set-point for 3-point stepping controller 19
- 3.5.8 Self-tuning start 20
- 3.5.9 Self-tuning cancellation 21
- 3.5.10 Acknowledgement procedures in case of unsuccessful self-tuning 21
- 3.5.11 Examples for self-tuning attempts 22
- 3.6 Manual self-tuning 23
- 3.7 Second PID parameter set 24
- 3.8 Alarm handling 25
- 3.9 Operating structure 27
- 4. Configuration level 28
- 4.1 Configuration parameters 29
- 4.2 Set-point processing 42
- 4.3 KS90-1 cooling functions 43
- 4.4 Configuration examples 44
- 4.4.1 On-Off controller / Signaller (inverse) 44
- 4.4.2 2-point controller (inverse) 45
- 4.4.3 3-point controller (relay & relay) 46
- 4.4.4 3-point stepping controller (relay & relay) 47
- 4.4.5 Continuous controller (inverse) 48
- 4.4.6 D - Y - Off controller / 2-point controller with pre-contact 49
- 4.4.7 Continuous controller with integrated positioner ( Cntr/ C.Fnc = 6 ) 50
- 4.4.8 Measured value output 51
- 5. Parameter setting level 52
- 6. Calibration level 56
- 7. Programmer level 59
- 8. Special functions 69
- 9. BlueControl 72
- 10. Versions 73
- 11. Technical data 74
- 12. Safety hints 78
- Index
- 0-9
- A
- B
- C
- D
- E
- F
- I
- L
- M
- O
- P
- R
- S
- T
- V