West Control Solutions KS 92-1 Programmer manual - Manual (Page 64)

Programmer parameter setting
8(16) programmers with 16 segments each are available to the user. The relevant
parameters must be determined in menu
ProG . ( r page 57).
The procedure for editing a program is shown below.
Select the program you want to edit by means of keys ID and confirm it with Ù .
Start by setting the bandwidth high and low ( b.Lo; b.Hi) limits and the control
output reset value ( d.00) for the selected program. The bandwidth is valid for all
segments ( r see chapter 7.3.6 ).
g
Configuration parameter pCom ( r page 38) can be used for display suppression
of bandwidth parameters and control output reset value, which, however, remain
valid.
Select the segment number (
SEg; Segm.-No) for the segment which is to be ed-
ited.
Now, enter segment type (
r page chapter ), segment end set-point, segment
time/gradient and control output.
After confirming parameter d.Out with key Ù , select the following segment.
Copying a program
The procedure for copying a program is shown below.
When confirming function COPY with key Ù , the program which shall be cop-
ied must be selected ( Src). Subsequently, the target program (dSt) must be ad-
justed. Press key Ù to start copying.
Programmer level
Programmer description 64 KS 90-1
p / KS 92-1 p
ProG
1199
para
Щ Щ Щ Щ
3 Sek.
1200
1199
Edit Prg
1199 1199
para para Program Prog. 01
М
М
Щ
М
М
Щ
1199
para
SEG
Segm.-No
Щ Щ
1199 1199 1199
para para para
b.Lo b.Hi d.00
BandLow BandHigh 0000
Щ Щ Щ Щ Щ
1199 1199 1199 1199 1199
para para para para para Time
SEG typE SP Pt d.Out
Segm.-No Setpoint Time 0000
Segm.-No + 1
ProG
1199
para
Щ Щ
Щ Щ
3 Sek.
1200
1199
Edit
Src dSt
1199
1199 1199
para
para para
Program
Ì
COpy
1199
para Program