West Control Solutions KS 92-1 Programmer manual - Manual (Page 30)

Configuration level
Configuration parameters 30 KS 90-1
p / KS 92-1 p
Name Value range Description Default
CYCL
Characteristic for 2-point- and 3-point-controllers 0
0 standard
3 with constant cycle
tunE
Auto-tuning at start-up 0
0 At start-up with step attempt, at set-point with impulse attempt
1 At start-up and at set-point with impulse attempt. Setting for fast
controlled systems (e.g. hot runner control)
2 Always step attempt at start-up
Strt
Start of auto-tuning 0
0 Manual start of auto-tuning
1 Manual or automatic start of auto-tuning at power on or when oscil-
lating is detected
Adt0 Optimization of T1, T2 (only visible with BlueControl!) 0
0 Automatic optimization
1 No optimization
1 rnG.L and rnG.H are indicating the range of control on which e.g. the
self-tuning is refering
q Prog
Name Value Range Description Default
t.bAS
Timebase of Programmer 0
0 hours [hh] : minutes [mm]
1 minutes [mm] : seconds [ss]
q InP.1
Name Value range Description Default
I.fnc
INP1 function selection 7
0 No function (following INP data are skipped)
1 Heating current input
2 External set-point SP.E (switch-over -> LOGI/ SP.E)
3 Position feedback Yp
4 Second process value x2 (ratio, min, max, mean)
5 External positioning value Y.E (switch-over r LOGI / Y.E)
6 No controller input (e.g. limit signalling instead)
7 Process value x1
S.tYP
Sensor type selection 1
0 thermocouple type L (-100...900°C) , Fe-CuNi DIN
1 thermocouple type J (-100...1200°C) , Fe-CuNi
2 thermocouple type K (-100...1350°C), NiCr-Ni
3 thermocouple type N (-100...1300°C), Nicrosil-Nisil
4 thermocouple type S (0...1760°C), PtRh-Pt10%
5 thermocouple type R (0...1760°C), PtRh-Pt13%
6 thermocouple type T (-200...400°C), Cu-CuNi
7 thermocouple type C (0...2315°C), W5%Re-W26%Re
8 thermocouple type D (0...2315°C), W3%Re-W25%Re
9 thermocouple type E (-100...1000°C), NiCr-CuNi
10 thermocouple type B (0/100...1820°C), PtRh-Pt6%
18 special thermocouple