KROHNE BM 102 Handbook - Manual (Page 78)

78 BM 102
F1 – Help Menu:
On-line help file.
F2 – Configuration Menu:
For creating and modifying gauge settings while PCSTAR 2 is connected to the gauge. The
configuration may also be created, modified or saved without sending the new settings to the gauge
in this window. The User configuration menu will be listed as shown in Section 3.3.1 of this manual.
The values displayed will be either default or customer-order specified values. Follow the
instructions in this section to configure the gauge.
Functions available on this page (use scroll slider on the right hand side to show all):-
User functions 1.1.1,1.1.2,1.1.3 & 1.1.6 : Basis Parameters
User functions 1.2.4, 1.2.5 & 1.2.6 : Display Parameters
User functions 1.3.1 to 1.3.5 : Current Output I Parameters
User functions 1.4.3 to 1.4.9 : User Data Parameters
User function 1.5.1 : Application Parameter
User function 1.6.2 : Serial Input/Output Parameter
User function 1.7.0 : Volume Table Parameters and…
F1 – Help :
F2 – Load from disk :
F3 – Exit:
F4 – Load from BM102:
F5 – Save to disk:
F6 – Send to BM102:
On-line help file
This loads old settings from the hard disk onto PCSTAR 2 (but not to
gauge).
Exit configuration page to real-time measurement main window.
This loads the configuration used by the gauge into PCSTAR 2.
Press to save a configuration onto disk in *.KRF format. This allows the
user to load configurations later and also facilitates analysis of the
gauge by KROHNE personnel if a problem is encountered.
Press this once all configuration parameters have been entered. This
will load the new configuration into the gauge.