KROHNE BM 102 Handbook - Manual (Page 6)

6 BM 102
Items included with supply:
The scope of supply encompasses:
• Signal converter with probe in the version ordered. The version is stated on the nameplate.
• PCSTAR 2 computer software for data display and gauge configuration.
Documentation supplied:
Installation & Operating instructions:
Installation, connection, start-up and safety advice in condensed form, but sufficient for most
applications. This is supplied as a printed document with the device delivered.
Handbook (this manual):
Detailed user manual and reference book, including how to configure meter parameters available in
the user menu and how to perform basic maintenance. This is not shipped with the level meter
ordered.
Supplementary Installation and Operating Instructions BM 102 KEMA 00 ATEX 1101X:
Supplementary instructions covering devices to be installed and used in hazardous areas. This
document is only supplied with specially approved instruments. This document is available from
your local KROHNE Sales office or on the “Download Centre” on KROHNE’s website
http://www.krohne.com/.
Product liability and warranty:
The BM 102 TDR level gauge is designed for measuring the distance, level, and volume of liquids,
pastes, slurries and powders. It may equally measure level, distance, total volume and ullage in
applications where two or more products are present.
Special codes and regulations apply to its use in hazardous areas. Please refer to the BM 102
MICROFLEX KEMA 00 ATEX 1101X Supplementary Installation and Operating Instructions for
further information. This document is available from your local KROHNE Sales office or on the
“Download Centre” on KROHNE’s website http://www.krohne.com/.
Responsibility as to suitability and intended use of these level gauges rests solely with the user.
Improper installation and operation of our level gauges may lead to loss of warranty.
In addition, the "General conditions of sale", forming the basis of the purchasing contract, are appli-
cable.
If you need to return measuring instruments to KROHNE, please note the information given in
Appendix C. KROHNE regrets that they cannot repair or check your device unless it is
accompanied by the completed form.
The level gauge does not form part of an overfill protection system (as defined for example in
WHG: German water resources act) nor is it concerned by the Pressure Equipment Directive (PED)
97/23/EC.