KROHNE BM 102 Handbook - Manual (Page 25)

BM 102 25
4. Define device interface: type F4 or left-click on “F4-Serial” at the bottom of the screen - to
define the interface to which the device is to be connected.
Serial Port
The serial port allows the user to select a free serial port (COM 1 to 4) on the
computer.
BM102 Address Type the “Address” that you have given a gauge (a value between 0 and 15)
and press ENTER or OK. This will select the required device. If you are in a
point to point network leave the box at its default value (-1).
Device Identifier Device Identifier refers to the “Device number” given in User Function No.
1.4.4.
Initial baud rate Transmission rate of data. Has a default value of 1200 bd.
RTS state The RTS state depends on the type of RS232 converter used. For
RS232<>HARTTM(i.e. VIATOR from MACTEK) use inversed RTS state.
5. On-line connection with the gauge: Press F2 or left-click on “F2-Connection” to set up the
connection with the device - the configuration parameters are automatically loaded into the
computer.
then …