KROHNE BM 70 A_P EN - Manual (Page 37)

Installation and operating instructions BM 70 A/P Page: 37 11/00
8.3 Operator control concept
main menu
column
Submenu
column
Functions
column
Data
column
Measuring mode
6 2 7
c m
Directions for using the keys in the menu levels and columns.
The flashing part of the display (cursor) can be changed.
CodE2
--
£ ¤ Error QUIT
NO ERROR
Error display
leaf through the
error list by
£
or
¤
or
QUIT NO •
¤
£
QUIT YES
•
•
•
Return to measuring mode
pressing
Note:
If after pressing a key "NO ACCESS" is displayed, this means that the keypad is temporarily blocked
owing to a configuration access via the signal output. The keys are available again after
Communication has finished.
When this displayed, enter the 9-keystroke Entry Code1,
see Fct. 3.4.3
Factory setting:
→ → → ↵ ↵ ↵ ↑ ↑ ↑
↵
→ CodE1
---------
Setting level
3.6 SW.OUTPUT.S 3.6.1 - 3.6.4
3.5 APPLICAT. 3.5.1 - 3.5.9
3.4 USER DATA 3.4.1 - 3.4.4
3.3 SIGNAL OUTP. 3.3.1 - 3.3.7
3.2 DISPLAY 3.2.1 - 3.2.5
3.0 INSTALL. 3.1 BASIS.PARAM 3.1.1 - 3.1.8
2.4 FIRMWARE 2.4.1 - 2.4.2
2.3 SW.OUTP.S 2.3.1
2.2 CUR.OUTP.I 2.2.1 - 2.2.2
2.0 TEST 2.1 HARDWARE 2.1.1 - 2.1.3
1.0 OPERATION 1.1 DISPLAY 1.1.1 - 1.1.3
Selection of
submenu
with the
↑
key
Setting the
data with the
→ ↑ ↵
keys
Selection of main
menu with the
↑
key
↵ ↵ ↵
↵
Parameter check
and return to
measuring mode
Selection of
function with
the
↑
key
→
→ →
→ →
↵
↵
↵
↵
↑
↑
→ ↑