KROHNE UFC 400 FOUNDATION FIELDBUS EN - Manual (Page 8)

4
OPERATION
8
UFC 400
www.krohne.com 05/2013 - 4002813701 - AD FF UFC 400 R01 en
4.1 Settable functions
• For Foundation Fieldbus the totalizers of the signal converter are not available!
• The following tables describe only the menus, functions and parameters that are different
between the standard signal converter and the Foundation Fieldbus signal converter.
• For the electrical connections of the outputs, inputs and all settings of functions that are not
listed in the following tables refer to the standard product documentation.
No. Displayed text Description and settings
A quick setup
A2 Tag Identifier for the measurement in a plant, appears in the display header
(maximum 8 digits).
Note: Only read, not changeable!
B test
B3.7 Foundation fieldbus Display information about Foundation fieldbus interface.
C setup
C5.1.1 Tag Identifier for the measurement in a plant, appears in the display header
(maximum 8 digits).
Note: Only read, not changeable!
C3 Totalizer Not available for Foundation Fieldbus devices!
C4 I/O HART Not available for Foundation Fieldbus devices!
C5.4 2. meas. page In case of Foundation Fieldbus device, the second measurement page is
meant to check the output values of the different function blocks. Only
Foundation Fieldbus values can be selected here. The analogue inputs are
shown with exactly the value, seen on the bus system.
C5.4.1 measurement 1.line Select: AI1...4 analog inp. / PID / INT1..2 integrator
C5.4.2 format 1.line Fixed number of digits after the decimal point or automatic, where the
number of digits is automatically adjusted to the available space.
C5.4.3 measurement 2.line Select: AI1...4 analog inp. / PID / INT1..2 integrator
C5.4.4 format 2.line Fixed number of digits after the decimal point or automatic, where the
number of digits is automatically adjusted to the available space.
C5.4.5 measurement 3.line Select: AI1...4 analog inp. / PID / INT1..2 integrator
C5.4.6 format 3.line Fixed number of digits after the decimal point or automatic, where the
number of digits is automatically adjusted to the available space.
C5.8 Foundation Field -
C5.8.1 Simulate Select: disabled / enabled
C5.8.2 Information Display information about hardware and software versions, the calibration
and test date of this interface.