Operation – KROHNE UFC 400 FOUNDATION FIELDBUS EN User Manual
Page 29
OPERATION
4
29
UFC 400
www.krohne.com
05/2013 - 4002813701 - AD FF UFC 400 R01 en
Time Stamp
R
The time when evaluation of the block was started and a
change in alarm/event state was detected that is unreported.
The time stamp value will be maintained constant until alert
confirmation has been received - even if another change of
state occurs.
Uninitialized
Setting:
MM / DD / YY (Month / Day / Year)
HH:MM:SS (Hour:Minute:Second)
Subcode
R
An enumeration specifying the cause of the alert to be
reported.
Other
Setting:
Other / Block Configuration / Link Configuration / Simulation
Active / Local Override / Device Fault State / Device
Maintenance / Input Failure / Output Failure / Memory
Failure / Lost Static Data / Lost NV Data / Readback Check /
Maintenance Needed / Power Up / Out Of Service
Discrete Value
R
The value of the associated parameter at the time the alert
was detected.
State 0
Setting:
Discrete State 0...16
WRITE_LOCK
WRITE_LOCK
WRITE_LOCK
WRITE_LOCK
Write Lock
R/W
If set, no writes from anywhere are allowed, except to clear
WRITE_LOCK. Block inputs will continue to be updated.
Not locked
Setting:
Uninitialized / Not locked / Locked
WRITE_PRI
WRITE_PRI
WRITE_PRI
WRITE_PRI
Write Priority
R
Priority of the alarm generated by clearing the write lock.
0
Setting:
0...15
DIAGNOSIS
DIAGNOSIS
DIAGNOSIS
DIAGNOSIS
Diagnosis
R
Detailed diagnosis of the device.
-
MEMORY_SUMMARY
Memory Summary
R
Summary of self diagnosis.
Uninitialized
Setting:
Task Control / RAM int / RAM ext / ROM boot area / ROM
application / FLASH / FRAM / EEPROM / bit08 / bit09 / bit10 /
bit11 / bit12 / bit13 / bit14 / bit15
FRAM_DIAG
FRAM Diagnosis
R
Result of FRAM self diagnosis.
Uninitialized
Setting:
ok , page high / warning : one header / warning : write
cycles / warning : uncertain / warning : inconsistent / write
error / chip error / page error / parameter error / bit09 /
changed / first init / wait / busy / unknown / not supported
action
workLOAD
R
Work load of the processor.
0
EMPTY_PIPE
EMPTY_PIPE
EMPTY_PIPE
EMPTY_PIPE
Status Empty Pipe
R/W
Defines the influence of the diagnostic ''Process : Empty
Pipe'' (FD_xx_13) to the TB measurements status (Fct.
C1.10.3).
Information
Setting:
Information / Maintenance Required / Checks in progress /
Out Of Specification / Failure
FORMAT_2P_1L
FORMAT_2P_1L
FORMAT_2P_1L
FORMAT_2P_1L
Form. 2.Page 1.Line
R/W
No. of decimal places for 1st line of 2nd page (Fct. C5.4.2).
X.X
Setting:
#X. / #X.X / #X.XX / #X.XXX / #X.XXXX / #X.XXXXX /
#X.XXXXXX / #X.XXXXXXX / #X.XXXXXXXX / automatic
Parameter
Parameter
Parameter
Parameter
DD name
Access
Description and settings
Initial Value