Operation – KROHNE UFC 400 FOUNDATION FIELDBUS EN User Manual

Page 24

OPERATION

UFC 400

www.krohne.com

05/2013 - 4002813701 - AD FF UFC 400 R01 en

FD_OFFSPEC_MASK

Offspec Mask

R/W

This parameter allows the user to suppress any single or

multiple conditions that are active, in this category, from

being broadcast to the host through the alarm parameter.

(11) (12) (13) (14)

(20) (21) (22) (23)

Setting:

(00) Check / (01) Electronics : Operation Info /

(08) Electronics : Power Fail / (10) Configuration : Totaliser /

(11) Process : Signal Unreliable / (12) Process : Signal Lost /

(13) Process : Empty Pipe / (14) Electronics : IO Connection /

(15) Process : Current input / (16) M Process /

(17) M Configuration / (18) M Electronics / (19) M Sensor /

(20) S Process / (21) S Configuration / (22) S Electronics /

(23) S Sensor / (24) C Process / (25) C Configuration /

(26) C Electronics / (27) C Sensor / (28) F Process / (29) F

Configuration / (30) F Electronics / (31) F Sensor

FD_OFFSPEC_PRI

Offspec Priority

R/W

This parameter allows the user to specify the priority of this

alarm category.

Setting:

0...15

FD_RECOMMEN_ACT

This parameter is a device enumerated summarization of the

most severe condition or conditions detected. The DD help

should describe by enumerated action, what should be done to

alleviate the condition or conditions.

Uninitialized

Setting:

(0):Not Initialized / (1):No Action Required / (2):Remove

Simulate Jumper! / (1)(01)(00):Keys can be used 60 sec. after

removal of optical interface. / (1)(01)(01):Check configuration

settings of display line 2. / (1)(01)(02):Check configuration

settings of display line 1. / (1)(01)(06): Set MODE_BLK.TARGET

at RB to AUTO / (1)(01)(07): Check Fieldbus Terminal and

Connection / (1)(01)(11): / (1)(01)(12): / (1)(01)(13): /

(1)(01)(14): / (1)(01)(15): / (1)(01)(30):After starting up the

converter will respond. / (1)(01)(31):Zero Calibration will stop

and normal behavior will follow. / (1)(02)(20): Select another

measuement for meas. page 2 / (1)(02)(21): Select another

measuement for meas. page 1 / (1)(02)(28): Select another

measuement for IO B or activate diagnosis meas. / (1)(02)(29):

Select another measuement for IO B or activate diagnosis

meas. / (1)(02)(30): Select another measuement for IO A or

activate diagnosis meas. / (1)(02)(31): Select another

measuement for IO A or activate diagnosis meas. /

(1)(03)(00):reserved / (1)(04)(00):reserved /

(1)(05)(00):reserved / (1)(06)(00):reserved /

(1)(07)(00):reserved / (1)(08)(00):reserved /

(1)(09)(00):reserved / (1)(10)(00):reserved / (1)(11)(28):Try to

establish a reasonable flow profile or check the fluid /

(1)(11)(29):Check the acoustic properties of the medium for

this path / (1)(11)(30):Check the acoustic properties of the

medium for this path /

Parameter

Parameter
DD name

Access

Description and settings

Initial Value