KROHNE UFC 400 FOUNDATION FIELDBUS EN - Manual (Page 59)

OPERATION
4
59
UFC 400
www.krohne.com 05/2013 - 4002813701 - AD FF UFC 400 R01 en
Units Index R/W Setting:
All units are possible.
-
Decimal Point R/W The number of digits to the right of the decimal point which
should be used by an interface device in displaying the
specified parameter.
0
OUT_TRIP OUT_TRIP OUT_TRIP OUT_TRIP
Output Trip Output Trip Output Trip Output Trip
R/W The first discrete output. -
Status R/W Setting:
Good Non Cascade / Good Cascade / Uncertain / Bad Not
Connected / Bad
Bad Not Connected
Value R/W Setting:
0: Off / 1: On
Off
OUTAGE_LIM OUTAGE_LIM OUTAGE_LIM OUTAGE_LIM
Outage Limit Outage Limit Outage Limit Outage Limit
R/W The maximum tolerated duration for power failure. 0
Setting:
Positive or 0
PCT_INCL PCT_INCL PCT_INCL PCT_INCL
Percentage Percentage Percentage Percentage
Increment Increment Increment Increment
Calculation Calculation Calculation Calculation
R Indicates the percentage of inputs with good status compared
to the ones with bad or uncertain and bad status.
0.0
PRE_TRIP PRE_TRIP PRE_TRIP PRE_TRIP
Pre Trip Pre Trip Pre Trip Pre Trip
R/W Adjusts the amount of mass, volume or energy that should set
OUT_PTRIP when the integration reaches (TOTAL_SP -
PRE_TRIP) when counting up or PRE_TRIP when counting
down.
0
Setting:
Positive or 0
PULSE_VAL1 PULSE_VAL1 PULSE_VAL1 PULSE_VAL1
Pulse Value 1 Pulse Value 1 Pulse Value 1 Pulse Value 1
R/W Determines the mass, volume or energy per pulse. 0.0
Setting:
Positive or 0
PULSE_VAL2 PULSE_VAL2 PULSE_VAL2 PULSE_VAL2
Pulse Value 2 Pulse Value 2 Pulse Value 2 Pulse Value 2
R/W Determines the mass, volume or energy per pulse. 0.0
Setting:
Positive or 0
RESET_CONFIRM RESET_CONFIRM RESET_CONFIRM RESET_CONFIRM
Reset Confirm Reset Confirm Reset Confirm Reset Confirm
R/W Momentary discrete value which can be written by a host to
enable further resets, if the option confirm reset in
INTEG_OPTS is chosen.
-
Status R/W Setting:
Good Non Cascade / Good Cascade / Uncertain / Bad Not
Connected / Bad / Bad No Comm with Last Useable Value
(LUV)
Bad Not Connected
Value R/W Setting:
0: Off / 1: On
Off
RESET_IN RESET_IN RESET_IN RESET_IN
Reset Input Reset Input Reset Input Reset Input
R/W Reset the totalizers. -
Status R/W Setting:
Good Non Cascade / Good Cascade / Uncertain / Bad Not
Connected / Bad / Bad No Comm with Last Useable Value
(LUV)
Bad Not Connected
Value R/W Setting:
0: Off / 1: On
Off
REV_FLOW1 REV_FLOW1 REV_FLOW1 REV_FLOW1
Reverse Flow 1 Reverse Flow 1 Reverse Flow 1 Reverse Flow 1
R/W Indicates reverse flow when true. -
Status R/W Setting:
Good Non Cascade / Good Cascade / Uncertain / Bad Not
Connected / Bad / Bad No Comm with Last Useable Value
(LUV)
Bad Not Connected
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value