KROHNE UFC 400 FOUNDATION FIELDBUS EN - Manual (Page 13)

OPERATION
4
13
UFC 400
www.krohne.com 05/2013 - 4002813701 - AD FF UFC 400 R01 en
DEV_TYPE DEV_TYPE DEV_TYPE DEV_TYPE
Device Type Device Type Device Type Device Type
R Manufacturer's model number associated with the resource -
used by interface devices to locate the DD file for the
resource.
UFC400
Setting:
UFC400
FAULT_STATE FAULT_STATE FAULT_STATE FAULT_STATE
Fault State Fault State Fault State Fault State
R Condition set by loss of communication to an output block,
failure promoted to an output block or a physical contact.
When fault state condition is set, then output function blocks
will perform their "FSTATE" actions.
Clear
Setting:
Uninitialized / Off / Clear
FD_CHECK_ACTIVE FD_CHECK_ACTIVE FD_CHECK_ACTIVE FD_CHECK_ACTIVE
Check Active
R This parameter reflects the error conditions that are being
detected as active as selected for this category. It is a bit
string, so that multiple conditions may be shown. See section
2.9.
-
Setting:
(00) Check / (01) Electronics : Operation Info /
(08) Electronics : Power Fail / (10) Configuration : Totaliser /
(11) Process : Signal Unreliable / (12) Process : Signal Lost /
(13) Process : Empty Pipe / (14) Electronics : IO Connection /
(15) Process : Current input / (16) M Process /
(17) M Configuration / (18) M Electronics / (19) M Sensor /
(20) S Process / (21) S Configuration / (22) S Electronics /
(23) S Sensor / (24) C Process / (25) C Configuration /
(26) C Electronics / (27) C Sensor / (28) F Process / (29) F
Configuration / (30) F Electronics / (31) F Sensor
FD_CHECK_ALM FD_CHECK_ALM FD_CHECK_ALM FD_CHECK_ALM
Check Alarm
This parameter is used primarily to broadcast a change in the
associated active conditions, which are not masked, for this
alarm category to a Host System.
-
Unacknowledged R/W A discrete enumeration which is set to "Unacknowledged"
when an alarm occurs, and set to "Acknowledged" by a write
from a human interface device or other entity which can
acknowledge that the alarm/event has been noticed.
Uninitialized
Setting:
Uninitialized / Acknowledged / Unacknowledged
Alarm State R A discrete enumeration which gives an indication of whether
the alert is active and whether it has been reported.
Uninitialized
Setting:
Uninitialized / Clear - reported / Clear - not reported /
Active - reported / Active - not reported
Time Stamp R The time when evaluation of the block was started and a
change in alarm/event state was detected that is unreported.
The time stamp value will be maintained constant until alert
confirmation has been received - even if another change of
state occurs.
Uninitialized
Setting:
MM / DD / YY (Month / Day / Year)
HH:MM:SS (Hour:Minute:Second)
Subcode R An enumeration specifying the cause of the alert to be
reported.
-
Value R The value of the associated parameter at the time the alert
was detected.
-
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value