Figure 3-8. saved setups menu, Saved setups menu -25, Ure 3-8): re – KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.4.12 and higher User Manual

Page 91: E 3-8). for, E 3-8)

BOP HIPWR 031014

3-25

FIGURE 3-8. SAVED SETUPS MENU

2. Use the

and

keys to highlight the desired memory location; To erase a highlighted

memory location, press

. The list will show erased locations as Empty.

3. Press

to see the details stored in the highlighted location.

4. Once the details are displayed, use the

and

keys to highlight the desired parameter.

NOTE: If a value to be saved is beyond the range of the unit, the value saved will be limited to

the maximum value. If the Mode is changed, the numerical values for the main and
protection channels must be revised accordingly.

• To modify the parameter, press

. Highlight the desired choice from a list, or use the

keypad to enter a numeric value, then press

to save, or

to abort.

• To exit without changing the parameter, press

5. Continue to modify parameters as described in step 4 above. When all parameters have

been modified, press

to save for power-up. Press

to exit without storing the

changes.

NOTE: If the message CHANGES NOT ALLOWED is displayed, the memory location has been

remotely locked (see PAR. A.12 for details).

6. After the changes have been saved, the unit returns to the Saved Settings screen, where

the saved settings can now be applied to the output by pressing

3.3.8.4

COPYING PREVIOUSLY SAVED SETTINGS TO A NEW LOCATION

1. Press

from the power-up screen to enter the Saved Setups screen (Figure 3-8).

2. Use the

and

keys to highlight the location to be copied, then press

VOLTAGE

SOURCE

VOLTAGE

CURRENT

0.0000 0.0000