KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.4.12 and higher - Manual (Page 28)

1-8
BOP HIPWR 031014
FUNCTION GENERATOR CHARACTERISTICS (Continued)
Amplitude Range
Main Channel Voltage (Volts p-p) 0 to 2 x EO
NOM
Sine, Triangle, Square, ±Ramp
Current (Amperes
p-p)
0 to 2 x IO
NOM
Sine, Triangle, Square, ±Ramp
Protection Limit Channel . Current, bipolar
(Amperes)
0 to IO
NOM
(set once for all segments)
Voltage, bipolar
(Volts)
0 to EO
NOM
Offset Voltage (Volts)
–EO
NOM
to +EO
NOM
Applies to offset of sine, triangle, ±ramp, and
square waveforms and to Level waveform
Amplitude.
Current (Amperes) –IO
NOM
to +IO
NOM
Amplitude Resolution (Programming)
Main Channel
and Offset
Voltage
(millivolts a-c)
.35 Sine
(millivolts d-c) 1 Triangle, Square, ±Ramp, Level:
Current
(milliamperes a-c)
.35 Sine
(milliamperes d-c) 1 Triangle, Square, ±Ramp, Level:
Protection Limit
Channel .
Current, bipolar
(Amperes)
0.1
Voltage, bipolar
(Volts)
0.1
Amplitude Accuracy
Main Channel
and Offset
Voltage 0.03% EO
NOM
Current 0.1% IO
NOM
Protection Limit.
Channel.
Current 0.5% IO
NOM
Voltage 0.3% EO
NOM
Distortion (THD-F, Total Harmonic Distortion
relative to the fundamental component) 5% max. Sine
13% max. Triangle
70% max. ±Ramp
47% max. Square
Start/Stop Angle
(Phase) Range
0 to 360°
Sine, Triangle
Programming Resolution 0.01°
Accuracy Start Angle 1°
Stop Angle 1° @ 0.01Hz, to 16° @ 443 Hz Frequency dependent
TABLE 1-2. BOP GENERAL SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION CONDITION