Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 299)

GPS Module
289
Adjust with Projection – Prompt Adjust
The Adjust with Projection Prompt Adjust screen is only shown when
the wizard opens automatically when you change the coordinate
system. This will be the case when you select a zone or site using the
Select Coordinate System screen, when you change or remove the
geoid using the Select Coordinate System screen, or when you change
the horizontal projection mode on the Survey > Projection screen.
The Prompt Adjust screen describes the difference between the two
coordinate systems, and gives you the option to adjust or to not adjust
the job.
1. Choose to Adjust job with new projection or
Do not adjust job
.
• If you pick Do not adjust job, then the
Next> button is hidden and the Done
button shows. Tap Done to update the
coordinate system but not change any
job file points.
• If you choose to Adjust job with new
projection
, you may have the choice to
Adjust all points
or to Adjust only points
with geodetic coordinates
. These two
cases are described in the Select Points section. The criterion
used to determine if this choice is allowed is based on the
nature of the change between the current and the new
coordinate system. This may be different for the horizontal
and vertical dimension. The title of the box will indicate the
dimension considered for this setting.
2. Tap Next> to open the Preview screen.