Watlow Silver Series - Manual (Page 16)

8 EZware5000 Series Programming Manual
The X-models (HMI5104XH, HMI5121X, and HMI5150X) have an additional icon in the System Setup Toolbar for
Screen Calibration.
Changing the System Settings
 To change the system settings on the HMI:
1. Open the System Setup Toolbar as described above, and click the System Settings icon.
2. A dialog will be displayed requesting the Local password. The default password is 111111.
 You may have to move windows around a bit to gain access to the virtual keyboard.
You may also have to click inside the password field again.
3. Once the correct password has been entered, the System Settings dialog is displayed. For all tabs, the Cancel,
Apply, and OK buttons are available.
Cancel Close the System Settings dialog without saving any changes.
Apply
Save the current settings without closing the System Settings
OK Save the current settings and close the System Settings dialog.
4. Click on the Network tab to configure network settings. The Network dialog is displayed.
5. The Network tab allows configuration of the IP settings. The default setting is Obtain an IP Address
Automatically. Use this setting if the HMI will obtain an IP address from a DHCP server. If connected to a
DHCP server, this dialog will display the IP settings obtained by the HMI. The IP fields are disabled and are
not editable.
Touch Panel Calibration
Older Models Newer Models
1010-1007, Rev. 10