Watlow Silver Series - Manual (Page 145)

Creating Windows 137
4. Click Settings... Click the Use shape checkbox, and then click the Shape Library… button.
5. Select a shape for your fast selection button and click OK.
6. Click OK.
 The Fast Selection window can only call full screen windows, not popup windows. Therefore, you cannot use
Function Key Objects configured to Display popup window in Fast Selection windows.
System Message Windows
EasyBuilder has four Windows designated as System Message windows. Window #5 is designated as the PLC
Response Window that pops up automatically when the HMI loses communications with the PLC.
Window #6 is designated as the HMI Response window, which will pop up automatically with the HMI loses
communications with another HMI that is remotely connected.
Window #7 is designated as the Password Restriction Window, which will pop up when access is attempted on a
protected object without the proper password. The Display warning message if access denied checkbox must be
enabled in the Security tab > User restriction section of the object.
These windows have been pre-configured with automated messages and a function key to close the window, so no
changes are necessary, though you may customize them for your own application if desired.
Window #8 is designated as the Insufficient Memory Window, which will pop up when the available memory in the
HMI, USB Flash drive, or SD card is running low. This window must be created by the programmer, and it can be
configured to indicate which device has triggered the message. The following Reserved Local Bits indicate insufficient
memory conditions:
LB9035 HMI free space insufficient alarm (when ON)
LB9036 SD Card free space insufficient alarm (when ON)
LB9037 USB 1 free space insufficient alarm (when ON)
LB9038 USB 2 free space insufficient alarm (when ON)
1010-1007, Rev. 10