Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" - Manual (Page 33)

35
Installation
En
g
lish
2 Attach the installation gaskets to the panel.
Installation gaskets are included for the standard mount orientation
and for the flat mount orientation.
Peel off the removable paper layer, and then attach the adhesive
surface to the rear surface of the resin plate as shown in the figure.
Follow the cross-section of the panel cut and attach the adhesive
surface on top of the installation gasket so that the adhesive
surface sticks out by approximately 3 mm (0.12 in.) past its
adjacent adhesive surface.
a) Boss when attaching installation brackets at the top and bottom
surfaces of the GP unit
b) Boss when attaching installation brackets on either side of the
GP unit
Note :
• Be sure to use the included installation gaskets.
• Due to the installation gasket properties, do not pull on the
installation gaskets while you attach them. Doing so may cause
the installation gaskets to be embedded in the installation
brackets.
• If the installation gaskets are used for a long time, the gaskets
may be damaged or dirt may affix to the gaskets, which may
cause their effectiveness to decrease. Replace the installation
gaskets periodically.
1) The installation gakets for Flat mount
2) The installation gakets for Standard mount
D
D
E
E
E
E
D
D
Rear surface of the panel
Cross-section
of the panel