10 cable connections – IEI Integration ECW-281B-N270-WT v3.01 User Manual
Page 70

ECW-281B/281B2-R30/N270 Embedded System
Page 55
4.2.9 Wireless Antenna Installation (Wireless Models Only)
To install an antenna to the wireless ECW-281B/281B2-R30/N270 series for efficient
wireless network transmission, follow the steps below.
Step 1:
Locate the antenna connector on the rear panel of the embedded system (refer
to
77
Figure 2-5
).
Step 2:
Install the antenna to the antenna connector (
77
Figure 4-13
).
Figure 4-13: Wireless Antenna Installation
4.2.10 Cable Connections
Once the system has been mounted on the wall, the following connectors can be
connected to the system.
VGA cable connector
Serial port connectors
RJ-45
connectors
USB devices can be connected to the system.
The cable connection locations are shown in
77
Figure 2-5
.